CITROEN C8 2005 - Page 167

163
ENGINE
Remove the screw (10).
Refit the upper timing cover (11), the lower timing cover (12), the pulley (9) and the screw (10).
Tightening method for the screw (10):
- Pre-tighten to : 3 ± 0,3 m.daN.
- Angular tighten : 180° ± 5°.
Remove tool [1].
Refit:
- The engine support (8), tighten to : 5,5 ± 0,9 m.daN.
- The RH engine support and upper torque reaction rod assembly.
- The nut (3), tighten to : 4,5 ± 0,5 m.daN.
- The three screws (5), tighten to : 5,5 ± 0,8 m.daN.
- The screw (6), tighten to : 6 ± 0,6 m.daN.
- The screw (4), tighten to : 6 ± 0,6 m.daN.
- The electrical harness (7).
Couple:
- The exhaust line, tighten to : 2,5 ± 0,3 m.daN.
- The fuel supply unions (1).
- The air/air heat exchanger inlet and outlet pipes (2).
Connect the connector at «a».
Refit:
- The accessories drive belt (see corresponding operation).
- The front RH splash-shield, the front RH wheel.
Reconnect the positive and negative terminals of the battery.
IMPERATIVE: Perform the operations that are necessary following a reconnection of the battery (see corresponding operation).
CHECKING AND SETTING THE VALVE TIMING
Engine: 9HZ
C5
Angl.T3-page032-190-2005 4/02/05 15:15 Page 163