169
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: RHL - RHR
Remove:
- The screw (8) and the auxiliaries drive pulley (7).
- The crankshaft position sensor (11).
- The lower timing cover (9).
- The target of the crankshaft position sensor (10), using tool [7].
- The lower torque reaction rod.
- The tool [6].
Slacken the screw (12) of the tensioner roller (17).
Remove the timing belt (13).
Checks.
IMPERATIVE: Just before refitting, carry out the checks below.
Check:
- That the rollers (14) and (17) turn freely (without play and without any tight spot).
- That the coolant pump pulley (16) turns freely (without play and without any tight spot).
- That there are no signs of oil leaks from the crankshaft and camshaft seals, etc.
- That the crankshaft pinion travels freely on the keyway (15).
Replace defective components if necessary.
B1EP1FCC
B1EP1FDC
B1EP1FEC
C5
Angl.T3-page032-190-2005 4/02/05 15:15 Page 169
To Next Page
Loading...
