172
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: RHL - RHR
B1EP1FKC
Turn the tensioner roller (clockwise), using a hexagonal spanner at «e».
Position the index «d» opposite the notch «f».
Tighten:
- The screw (12) of the tensioner roller (17) to 2,1 ± 0,2 m.daN.
- The auxiliaries drive pulley to 7 ± 0,7 m.daN.
Remove tools [3] and [6].
Rotate the crankshaft two times (in the direction of rotation of the engine).
Refit tools [2] and [3].
Check the position of the index «d», it should be opposite the notch «f».
IMPERATIVE: If the position of the index «d» is not correct, restart the operations to tension the
timing belt (for this, slightly slacken the screw (12) of the tensioner roller).
C5
Angl.T3-page032-190-2005 4/02/05 15:15 Page 172
To Next Page
Loading...
