2) From the Core Configuration Manager, navigate to Assignments.
3) Select the 4-Wire Direct tab in the Assignments page.
4) Click on the Add Direct Connection button to create a new direct connection
box or select an existing direct connection box. Make sure the connection box
you wish to add a port to has an orange highlight to indicate that it is
selected.
5) Navigate to Devices in the left hand margin of the screen.
6) Assign the required port to the direct connection by clicking ‘+’.
7) You will see the interface port appear inside the direct box.
8) Repeat steps 5 and 6 to add a second port to the direct box, connecting the
ports within it.
9) To unassign the port from the direct connection click ‘-‘ within the direct box
icon.
Click ‘+’ to
assign port to
Direct 1
Direct 1 has an orange
highlight. This shows
that it has been clicked
and is ‘selected’.
To Next Page
Loading...
