3 Powering your LQ™
Figure 3-1 LQ unit rear panel (2-wire device)
3.1 Using the power supply unit (PSU)
• LQ units are supplied with a 24 watt sleeve-locking power connector.
• LQ-R 1RU units are supplied with two 60 watt sleeve-locking power
connectors. Use either power connector, or both to guard against one
power supply failing.
Note: When connecting the sleeve-locking power cable, be sure to push until the
connector locks into the device.
3.1.1 Understanding power display icons
You will be able to see the power status of your device is from:
• The front panel of the unit
• The device icon in the web based configuration tool (the CCM).
These indicators will show if the unit is using PoE or the PSU (LQ throw-down
units), and which of the two power supplies (or both) are in use for the LQ-R units.
Audio ports (2W or 4W)
LAN2 connector
LAN1/PoE connector
Sleeve-locking
power connector
Grounding screw
To Next Page
Loading...
