3.2 Using power over Ethernet (PoE) with 2-port units
The 2-port units will receive power from the LAN1/PoE connector if required (this is
not the case for the larger LQ-R units).
When using PoE the LQ-2W2 supplies approximately 70 mA of power to the 2-wire
interface.
Note: If you are powering more than two LQ devices from one PoE switch, please consult
the power output of the PoE switch, as you may reach the limits of its power
capacity with more than two boxes.
If this happens, the device(s) will show a persistent flashing green light, and not
move beyond the Clear-Com splash screen. This indicates that the device is
continually booting and needs more power than the PoE switch or network is
providing. In this case, consider using the supplied sleeve-locking power connector
cable to power the device.
3.3 Re-boot system
The system will start its boot sequence immediately when power is applied. If you
need to reboot for any reason, either cycle the power or press all four direction
keys on the control panel on the front of the LQ unit at the same time.
To Next Page
Loading...
Need help?
General
