14.4 What does a persistent flashing green light (more
than 2 minutes) on the front panel keypad
indicate?
The devices boot automatically when power is supplied and show a flashing green
light on the front panel keypad while the system is booting.
If the device is booting (the flashing green light does not turn into a solid green
light) for more than 2 minutes, and the display screen does not move beyond the
Clear-Com splash screen, the most likely explanation is that the unit does not have
enough power. This can happen if too many LQ devices are drawing power from
the same PoE switch or network.
Please check the power supply provided by PoE to see if this is the case and
consider using the supplied power connector cable to power the devices.
14.5 What types of 2-wire intercom do LQ Series units
support?
• Clear-Com
• RTS TW
14.6 Can I connect Clear-Com intercom panels to LQ 4-
wire devices?
Yes, Version 2 firmware and later supports Clear-Com Eclipse ECS/EHX matrix to
panel connections.
Matrix+3 connections are not supported.
To Next Page
Loading...
