Chapter 3: To use easyMail
Distress functions (only SAILOR 6150) 27
3333
4. If necessary, change the position, course and speed.
5. Select the nature of the Distress.
6. Click OK.
Reset alarm/latest Distress info
After sending a Distress alert or receiving an urgent/distress priority EGC or
message, you can reset the alarm light and sound in the alarm buttons. At
the same time you can see status on Distress alerts and Distress test. Do as
follows:
1. Select Distress > Reset alarm/latest Distress info.
A popup window shows information on the latest Distress Alert and the
latest Distress test.
2. Click OK.
The light and sound in the alarm button(s) are switched off.
Do not change the default setting unless you have good
reasons to do so. The default setting is “Always use latest
position from GPS”. It is normally best to show your current
GPS position when sending a Distress Alert.
You may need to change the position, e.g. if the person(s) that
need help are no longer on board the ship (man overboard).
To Next Page
Loading...
