Codonics Virtua - Logging In

Codonics Virtua User’s Manual 3-3
Setting Up the Software
NOTE: If touching the button does not start the calibration utility, the Touch Screen
calibration might be very far off. Try touching the area around the button until the button
activates.
The Alignment screen displays.
2. Three targets display on the Alignment screen one-by-one.
Carefully touch the center of each target.
When the calibration is complete, the Login screen displays
again.
Preconfigured User Accounts
Two user accounts are preconfigured to allow initial access to the
application:
• admin , which provides access to both standard and
administrator functions
• virtua , which provides access to standard functions
The default password for both preconfigured user accounts is
codonics .
NOTE: To prevent unauthorized access to the application, you should change the password
for these user accounts the first time you log in. For more information, refer to “Changing a
User’s Password and Administrator Privileges” on page 3-14.
3
Logging In
3