InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
For modem use the COM1 port instead.
12.2.3.6 Setpoint: RS232(1)MBCSpd
9600, 19200, 38400, 57600 [bps]
The setpoint adjusts the communication speed on the COM1 connector when
it is switched to MODBUS or MODBUS-MDM(HW) mode. See also the
setpoint RS232(1) mode.
12.2.3.7 Setpoint: RS232(2)MBCSpd
9600, 19200, 38400, 57600 [bps]
The setpoint adjusts the communication speed on the COM2 connector when
it is switched to MODBUS or MODBUS-MDM(HW) mode. See also the
setpoint RS232(2) mode.
12.2.3.8 Setpoint: RS232(1)MdmIni
This setpoint can be used to add extra AT commands at the end of the
initialization sequence of the modem connected to the COM1 port. The
command can be entered with as well as without the "AT" prefix, are
separated with semicolon and maximal length is 31 characters.
The setpoint can't be modified via the IG-NT built-in terminal.
12.2.3.9 Setpoint: RS232(2)MdmIni
To Next Page
Loading...
Need help?
General
