ComAp IGS-NT Series User Manual

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
28
4 Putting it into operation
In this section brief introduction how to
 connect to a controller,
 modify various settings,
 program controller and reprogram non-responsive controller,
 manage passwords and password protections and
 operate related tools (ScreenEditor, PLC Editor etc.)
is presented.
4.1 Connection to a controller using PC
There are several available ways to connect to controller using PC for monitoring, control or
configuration/programming. For more information on related PC tools please refer to the section
2.2 Configurability and monitoring.
4.1.1 Direct connection
A direct connection can be realized by RS232 connection or USB connection (available on NTC
BaseBox only). Figures below illustrate the connection setting in GenConfig and InteliMonitor.
GenConfig
InteliMonitor
Select according COM port, adjust CAN address and enter password (optional for locked
configuration).

ComAp IGS-NT Series Specifications

General

Brand	ComAp
Model	IGS-NT Series
Category	Controller
Language	English