InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
2 System overview
2.1 General description
InteliMains-NT controller is comprehensive mains supervision controller for multiple generating sets
operating in parallel to the Mains. A modular construction allow upgrades to different levels of
complexity in order to provide the best solution for various customer applications.
NT Family controllers are equipped with a powerful graphic display showing icons, symbols and bar-
graphs for intuitive operation, which sets, together with high functionality, new standards in Gen-set
controls.
BaseBox versions of InteliMains controllers is now available. This version features controller without
built-in monochromatic display and can be combined with new and powerful display units InteliVision-8
and InteliVision-5. For more information on these products, please go to comap.cz web pages.
The controller automatically connects and synchronizes two parts of bus bar and controls the bus tie
circuit breaker (BTB).
The key feature of the controller is its easy-to-use operation and installation. Predefined configurations
for typical applications are available as well as user-defined configurations for special applications.
The key features are:
BTB controlled by InteliMains-NT
Highly customizable behavior of breaker control (dead bus, blockation of closing etc.)
Synchronization (voltage and phase matching) of two control groups separated by InteliMains-
BTB with various settings (which group synchronizes to which etc.)
Load shedding control (based on power transferred via BTB)
Full PLC logic included (useful in complex systems – BTB can for example serve as auxiliary
PLC for other controllers)
Support of redundancy controller
Full set of protections for BusL and additional protections for BusR
Group Link function
Active calls and SMS
To Next Page
Loading...
Need help?
General
