ComAp IGS-NT Series User Manual

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
48
FUNCTION NAME
(ALPHABETICAL
ORDER)
BRIEF DESCRIPTION
RELATED SETPOINTS, INPUTS AND
OUTPUTS
Internet related
communication
functions
AA
It is possible to connect controllers to
Internet. AirGate function is also
available when Internet connection is
established. Active emails may be sent
upon various reasons. For more
information on these functions please
refer to a separate chapter.
IP Addr mode
IP address
Net mask
Gateway IP
ComApProtoPort
AirGate
AirGate IP
DNS IP
NumberRings AA
Language
selection
InteliMains can change language in its
built-in display as well as in attached
displayes by activation of binary inputs.
LANG SEL INT A
LANG SEL INT B
LANG SEL INT C
LANG SEL D#2 A
LANG SEL D#2 B
LANG SEL D#2 C
LANG SEL D#3 A
LANG SEL D#3 B
LANG SEL D#3 C
Load shedding
function
AA
Complex load shedding and
reconnection function is available in the
controller. It is described in the separate
chapter.
Ld shed active
Ld shed level
Ld shed delay
Ld recon level
Ld recon del
AutoLd recon
LDSHED STAGE 1
LDSHED STAGE 2
LDSHED STAGE 3
MANUALLDRECON
Mains Coupling
This function defines if Mains Coupling is
enabled via controller breaker. It should
be enabled only if two or more Mains
incommers are in phase and it is allowed
by local authorities.
Mains coupling
Measurement of
P and Q
selection
You may select the source of Mains
current measurement or disable this
measurement.
I/E-PbL meas
I/E-QbL meas
I/E-PBL
I/E-QBL
Permanent
logical 0 or 1
outputs
It is possible to use permanent logical
binary function that is always logical 0 or
logical 1. It may used for various
purposes.
LOGICAL 0
LOGICAL 1
i
i

ComAp IGS-NT Series Specifications

General

Brand	ComAp
Model	IGS-NT Series
Category	Controller
Language	English