InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
4.1.4 Airgate connection
AirGate connection can be used directly in NTC BaseBox version of the controller. For connection to
other versions, use IntenetBridge-NT device. Figures below illustrate the connection setting in
GenConfig and InteliMonitor.
Enter AirGate address of a server with AirGate service (currently airgate.comap.cz). Select CAN
address of the controller you want to connect to. Enter AirGate ID of the controller (InternetBridge) you
want to connect to (AirGate ID is assigned automatically if the controller is properly connected to the
Internet and corresponding AirGate setting is enabled. You can find AirGate ID in controller values.).
Enter Access Code for remote connection. Enter password (optional for locked configuration).
NOTE:
What is AirGate service? AirGate is a service provided for free by
ComAp which allows users to connect to controllers even though they
are not assigned public IP address or if there are behind corporate
firewalls. Controller connects to the AirGate server (secure and fast
server located in Central Europe) and obtains AirGate ID (used in the
connection, see above). Then it communicates with the server on a
secure line and any user that know AirGate ID and access code for
that particular controller can connect from anywhere (Internet access
needed) to the controller and monitor and control it.
To Next Page
Loading...
Need help?
General
