ComAp IGS-NT Series - Page 7

IGS-NT Installation Guide
7
20.12. IGS-PTM ......................................................................................................... 143
20.12.1. Binary inputs ............................................................................................... 143
20.12.2. Binary open collector outputs ...................................................................... 143
20.12.3. Analog inputs .............................................................................................. 144
20.12.4. Analog output .............................................................................................. 144
20.13. IS-AIN8 ........................................................................................................... 144
20.13.1. Analog inputs .............................................................................................. 144
20.14. I-AOUT8 .......................................................................................................... 145
20.15. IS-BIN16/8 ...................................................................................................... 145
20.15.1. Binary inputs ............................................................................................... 146
20.15.2. Open collector outputs ................................................................................ 146
20.15.3. Frequency inputs ......................................................................................... 146
20.16. IGL-RA15 ........................................................................................................ 146
20.16.1. Power supply ............................................................................................... 146
20.16.2. Operating conditions ................................................................................... 146
20.16.3. Dimensions and weight ............................................................................... 147
20.16.4. Horn output ................................................................................................. 147
20.17. I-CB, I-CR ....................................................................................................... 147
20.17.1. Power supply ............................................................................................... 147
20.17.2. Operating conditions ................................................................................... 147
20.17.3. Dimensions and weight ............................................................................... 147
20.17.4. CAN bus interface ....................................................................................... 147
20.17.5. RS232 interface .......................................................................................... 148
20.18. I-LB ................................................................................................................. 148
20.19. IG-IB ............................................................................................................... 148
20.20. I-RBxx ............................................................................................................. 148
20.21. IG-MTU ........................................................................................................... 148
20.22. IG-MTU-2-1 ..................................................................................................... 149