InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
13.1.9 Group: Bin inputs CU
13.1.9.1 Value: BIN
This is a bit array containing status of physical binary inputs of the controller.
Bit0 represents BI1, bit1 represents BI2 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
13.1.10 Group: Bin outputs CU
13.1.10.1 Value: BOUT
This is a bit array containing status of physical binary outputs of the
controller. Bit0 represents BO1, bit1 represents BO2 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
To Next Page
Loading...
Need help?
General
