InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
13.1.11 Group: Log Bout
13.1.11.1 Value: LogBout 1
This is a bit array containing status of logical binary outputs 1-16 of the
controller. Bit0 represents LBO1, bit1 represents LBO2 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
13.1.11.2 Value: LogBout 2
This is a bit array containing status of logical binary outputs 17-32 of the
controller. Bit0 represents LBO17, bit1 represents LBO18 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
To Next Page
Loading...
Need help?
General
