InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
13.1.12.25 Value: Latitude
This value contains latitude of the controller. This value is obtained from
connected IB-NT with active GPS. Time is automatically synchronized as well
when succesfull GPS fix is established. If no valid value is available from
InternetBridge-NT, value ##### is displayed.
13.1.12.26 Value: Longitude
This value contains longitude of the controller. This value is obtained from
connected IB-NT with active GPS. Time is automatically synchronized as well
when succesfull GPS fix is established. If no valid value is available from
InternetBridge-NT, value ##### is displayed.
13.1.13 Group: Statistics
13.1.13.1 Value: Sum MWh
In BTB - this value shows always 0.
This value shows the total sum of MWh counted from all the genset in the
according control group. If two separate control groups are connected by
group link this value shows sum of MWh from both connected control groups.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
To Next Page
Loading...
Need help?
General
