InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
This is a bit array containing status of logical binary outputs 65-80 of the
controller. Bit0 represents LBO65, bit1 represents LBO66 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
13.1.11.6 Value: LogBout 6
This is a bit array containing status of logical binary outputs 81-96 of the
controller. Bit0 represents LBO81, bit1 represents LBO82 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to
right. That means the bit 0 is displayed in the most left position. This is
different from common use in computer science, where binary values are
displayed from right to left.
NOTE:
Click on button with "..." to get a clear list of BI names with their
corresponding values.
13.1.11.7 Value: LogBout 7
To Next Page
Loading...
Need help?
General
