ID–Lite-2.0 User guide, ©ComAp – January 2011 4
ID-Lite-2.0 User guide.pdf
General guidelines
What describes this manual?
This manual describes ID-Lite application examples for single engine applications.
This manual is dedicated for
Operators of engines.
Engine control panel builders.
For everybody who is concerned with installation, operation and maintenance of the engine
applications.
!! Warnings !!
Remote control
InteliDrive-Lite controller can be remotely controlled. In case of the work on the engine check, that
nobody can remotely start the engine.
To be sure:
Disconnect remote control via RS232 line
Disconnect input REM START/STOP
or
Disconnect output STARTER
Because of large variety of InteliDrive-Lite parameters settings, it is not possible to describe any
combination. Some of InteliDrive-Lite functions are subject of changes depend on SW version.
The data in this manual only describes the product and are not warranty of performance or
characteristic.
Text
PAGE (Capital letters in the frame) buttons on the front panel
Break Return (Italic) set points
Engine protections (Bold) Set point group
REMOTE START/STOP (Capital letters) binary inputs and outputs
Note:
ComAp believes that all information provided herein is correct and reliable and reserves the right to
update at any time. ComAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
Note:
SW and HW must be compatible (e.g. ID-Lite firmware and ID-Lite HW) otherwise the function will be
disabled. If wrong software is downloaded the message HARDWARE INCOMPATIBLE appears on
controller screen. In this case use Boot load (jumper) programming – close Boot jumper and follow
instructions in LiteEdit, download correct software.
To Next Page
Loading...
