ID–Lite-2.0 User guide, ©ComAp – January 2011 68
ID-Lite-2.0 User guide.pdf
Step: 1
Range: 0 – 10000
Default: 100
LoadDnLimit [ - ]
Load limit regulator PI output low limit.
Step: 1
Range: 0 – 10000
Default: 9900
Load Gain [ % ]
Regulator gain.
Step: 0,1
Range: -200,0% – +200,0%
Default: 0
Load Integral [ % ]
Regulator integration factor.
Step: 0,1
Range: 0% – +100,0%
Default: 0
Load CMP Input [ RPM, ECU:Load,
CU: IA1, CU: AI2, CU: AI3, AIO: IA1, AIO: AI2, AIO: AI3, AIO: AI4 ]
Comparator with hysteresis analog input selection or from central unit (CU) or from plug-in (AIO).
Load CMP Off
Limit to close LBO LoadSwitch
Step: 1
Range: -10000 – +10000
Load CMP On
Limit to open LBO LoadSwitch
Step: 1
Range: -10000 – +10000
Engine protect
Eng prot del [s]
During the start of the engine, some engine protections have to be blocked (e.g. Oil pressure).
The protections are unblocked after the Protection del time. The time starts after reaching Start RPM.
Step: 1s
Range: 0 – 300 s
BIN6 delay [s]
Specific protection delay adjustable on Binary Input 6. Delay is active for Wrn or Sd protection only -
not for functions like Rem Start/Stop. Protection delay is active for both Binary input NO / NC
configuration. BIN6 del starts after Eng prot del when BI6 protection is configured “Running only”.
Step: 1s
Range: 0 – 300 s
To Next Page
Loading...
