ID–Lite-2.0 User guide, ©ComAp – January 2011 58
ID-Lite-2.0 User guide.pdf
COM2 Mode [DIRECT/MODBUS/ECU LINK]
Communication protocol switch for the COM2 channel, if dual communication module is plugged in.
DIRECT: LiteEdit communication protocol via direct cable.
MODBUS: Modbus protocol. See detailed description in InteliCommunication guide.
ECU LINK: Protocol for communication with Cummins engines via Modbus.
Hint:
For details on communication speed and other technical parameters please see chapter Technical
Data.
For detail description of communication possibilities see actual Inteli Communication Guide xxx.pdf -
chapter Modbus protocol and others.
ModemIniString
If your modem needs some additional initialization AT commands (i.e. because of national telephony
network differences), it can be entered here. Otherwise leave this setpoint blank.
ModbusComSpeed [9600,19200, 38400, 57600]
If the Modbus mode is selected on COM1 or COM2 channels, the Modbus communication speed in
bps can be adjusted here.
IBLite IP Addr
IP address of IB-Lite module
IBLite NetMask
IB-Lite network mask
IBLite GateIP
IP address of gateway for IB-Lite
ComAp Port
Port for ComAp communication over IB-Lite or IL-NT-GPRS module
APN Name
Name of APN access point for GPRS network.
Hint:
This information shall provide the your GSM/GPRS operator.
APN UserName
User name for APN access point.
Hint:
This information shall provide the your GSM/GPRS operator.
APN UserPass
User password for APN access point.
Hint:
This information shall provide the your GSM/GPRS operator.
AirGate IP
IP address of AirGate server.
SMTP UserName
User name or name of e-mail account for verification of email sender on SMTP server. If parameter
left empty, no verification is expected. Works for IB-Lite only.
To Next Page
Loading...
