InteliVision 8
41
4.3.1 Change of the numerical value
1. Press the button from the context menu on the right (e.g. Basic settings).
2. Use ↑ ↓ to go to a certain setpoint (e.g. Gear teeth) and press Enter.
Image 4.27 Edit of setpoint with a numerical value
3. Use → ← buttons to go to a certain position of the field and use ↑ ↓ buttons to change the value. Then press
Enter. For quicker movement among value positions it is possible to move cyclic through value with using →
←buttons. It means from the highest digit place to the lowest digit place and vice versa.
Note: If you set the value out of limit, the field will color red and you will not be able to confirm the value.
To Next Page
