Comau Robotics Product Instruction
64
MULTICONTROL PANEL
5. MULTICONTROL PANEL
5.1 Introduction
This area (highlighted in the figure above), alwais displayed, is dedicated to the Control
Units which RoboShop can connect and communicate to.
As already stated, RoboShop is able to connect to more than one Control Unit at
simultaneously, in the same session.
The Multicontrol Panel (figure above) is composed by:
– Multicontrol Bar (3.1)
– Nodes Panel (3.2)
– Details Panel (3.3).
5.2 Multicontrol Bar
This bar provides the needed commands to handle the Control Unit which can interact
with RoboShop. With reference to the figure above, from left to right, the following
commands are available:
– Add new node
To Next Page
Loading...
