E.DO CLEANING INSTRUCTIONS AND PERIODIC CHECKS
61
Comau Robotics Product Instruction
7.2 e.DO cleaning
When is the e.DO cleaning required?
The general cleaning of e.DO must be performed at the end of each use.
In case of long periods of non-use, it is recommended to put e.DO inside the original
packaging or cover it appropriately with special sheets / nylon, to protect it from dust.
How to clean e.DO?
The general cleaning of e.DO must be performed using a soft bristle brush or soft damp
cloth. Do not use abrasive products, abrasive sponges, solvents or metal objects.
Carefully clean the Robot base and the related areas of the connectors; clean the
perforated plastic covers on each Robot joint. If not used, carefully clean the threaded
holes for tool installation present at the end of the Robot (Robot wrist flange).
Before carrying out any cleaning operation, make sure that the Robot is powered off and
remove the plug from the power socket.
To Next Page
Loading...
