Configuration 5
October 2013 GB 37 /80
Set baudrate
1
Tap button <Baudrate>.
– The input menu for setting the baudrate ap-
pears.
2
Tap the <Baudrate> button for the desired
value.
Baudrate entry can be cancelled by tapping the
button <Cancel>. The previously active setting
is used.
3
Tap the <OK> button.
✓ The baudrate is set.
–
The menu "Communication" appears.
5.5.6 Setting automatic restart after a
power failure
DANGER
In this operating mode, the compressor
may start up automatically at any time.
➯
Provide the compressor with warn-
ing signs.
➯
Keep the compressor room locked.
➯
Instruct personnel.
➯
Install the main switch according to
EN 60204 and attach a warning sign
to it.
5.5.6.1 Automatic re-start
The controller can be set so that the compressor
automatically restarts after a power failure.
The permissible duration of a power failure can be
set. If the duration of the power failures exceeds
the set time, the compressor will not restart auto-
matically. The fault message "E400:Power Sup-
ply Failure" appears in the display. In this case the
compressor must be manually started.
If the compressed air station comprises several
compressors, setting of start delay allows a stag-
gered start-up.
Activating automatic restart
1
Tap the <Settings> tab.
2
Tap the <Control...> button.
3
Press the <arrow keys> until the <Automatic
re-start> button appears.
4
Tap the <Automatic re-start> button.
–
The input menu "Automatic re-start" opens.
5
Tap the <On> button.
The <Cancel> button can be used to cancel en-
abling of the automatic restart. The previously
active setting is used.
6
Tap the <OK> button.
✓ Automatic restart after a power failure is en-
abled.
–
The "Control" menu appears.
–
On the <Automatic re-start> button the text
changes to "On".
–
In the menu "Home" it is also indicated that
automatic restart is enabled.
Tapping the button <Off> in the menu "Automatic
re-start" causes automatic restart to be disabled
again.
Setting the maximum power loss time
1
Tap the <Settings> tab.
2
Tap the <Control...> button.
3
Press the <arrow keys> until the <- Max. Power
Loss Time> button appears.
4
Tap the <- Max. Power Loss Time> button.
–
The input menu "- Max. Power Loss Time"
opens.
5 Tap the <arrow keys> to set the desired maxi-
mum power loss time.
The <Cancel> button can be used to cancel
setting of the maximum power loss time. The
previously active setting is used.
6
Tap the <OK> button.
✓ The maximum power loss time is set.
–
The "Control" menu appears.
– The set power loss time is now displayed on
the button <- Max. Power Loss Time>.
NOTE
The power loss time can be set to "unlimited".
This is not permissible in some countries. Con-
tact Gardner Denver for advice.
To Next Page
Loading...
Need help?
General
