11 Appendix
76 / 80 GB October 2013
Display Explanation
Attention: Start after external start request
approval...
If a programmable input with the function "Start
Requ. Approval" has been activated, the compres-
sor starts as soon as the expected enable has been
granted at this input.
Attention: Starting in "x" s after Power Loss…
Attention: This Compressor has experienced a
power loss. It will automatically restart in “x” sec-
onds.
Attention: Starting in "x" min after Dryer Pre-Run
Time…
Attention: This Compressor will automatically start
as soon as the Dryer Pre-run time has elapsed.
Initialising VSD...
(RS) The VSD is being initialised.
Parameterizing VSD (x %)…
(RS) Sending parameters to configure the con-
verter.
Chart 11-1: Status messages
11.2 Settings
Compressor Data
The compressor reference number and the setup
codes can be entered in this table.
Compressor identifica-
tion number
The setup code
Chart 11-2: Compressor Data
Adjustment values
The adjustment values from the "Settings" menu
can be entered in this table.
Parameters Number / Setting
Hour Meters
Hours Run
Hours On-load
Hours to next Service
Control
p1 Cut-Out Point
p1 Cut-In Point (FS) /
p1 Target Pressure
(RS)
p2 Cut-Out Point
p2 Cut-In Point (FS) /
p2 Target Pressure
(RS)
Operating mode
Remote Start Enabled
Chart 11-3: Adjustment values
Parameters Number / Setting
Timer start enabled
p2 Timer Enabled
Automatic re-start
- Max. Power Loss Time
- Restart Delay
Dryer Pre-Run Time
Timer Start/Stop
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
Timer Pressure Band p2
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Chart 11-3: Adjustment values