CompAir DELCOS XL Series User Manual

Appendix 11
October 2013 GB 77 /80
Parameters Number / Setting
Channel 8
Programmable Inputs and Outputs
Input 1
Input 2
Input 3
Input 4
Input 5
Output 1
Output 2
Output 3
Output 4
Communication
RS485:1 Address
RS485:1 Baudrate
RS485:3 Address
RS485:3 Baudrate
Configuration
Language
Temperature Unit
Pressure Unit
Volume Flow Unit
Maximum Volume Flow
Minimum Volume Flow
(RS)
Ext. Speed Limit (min)
(RS)
Ext. Speed Limit (max)
(RS)
Factory Settings
Operating pressure
Start Requ. Approval
Heavy Startup (FS)
Discharge Temp. Warn-
ing
Discharge Temp. Fault
Minimum Start Tem-
perature
Chart 11-3: Adjustment values
Parameters Number / Setting
Run-On Time
Soft Stop Time
Star-Delta (FS)
Software version
Controller Ref.-No.
Replacement cycle
Replacement remain-
ing
Base Load Sequencing
Setpoints
p1 Cut-Out Point
p1 Cut-In Point
p2 Cut-Out Point
p2 Cut-In Point
Timer Start Enabled
p2 Timer Enabled
Behaviour
Start delay
Load Net in
Network Size
Timer Control
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
Configuration
Number of Slaves
Transfer Interval
Chart 11-3: Adjustment values
1 Version dependent, see the compressor
operating instructions

CompAir DELCOS XL Series Specifications

General

Brand	CompAir
Model	DELCOS XL Series
Category	Controller
Language	English