CompAir DELCOS XL Series User Manual

Setting Up a Replacement Controller 9
October 2013 GB 59 /80
Home
Mo.
Press the Emergency Stop Button
to test
Fig. 9-6: Request "Press Emergency Stop Button"
1 Press the <Emergency-stop> pushbutton.
–
The message "Emergency Stop Activated"
is displayed.
–
The symbol on the <Fault History> tab
flashes.
2 Unlock the <Emergency-stop> pushbutton.
3
Tap the <Fault History> tab.
4
Tap the <Reset> button.
–
The symbol on the <Fault History> tab
stops flashing.
✓ The controller is ready for use.
Checking settings
NOTE
All specific settings should be recorded, so that
if necessary they are available (e.g. for setting
up a replacement controller).
The settings can be entered in the "Adjustment
values" table in the appendix to these operating
instructions.
Before the compressor is started for the first time
after installation of the replacement controller, all
settings must be checked.
In particular, the specific settings must be re-en-
tered.

CompAir DELCOS XL Series Specifications

General

Brand	CompAir
Model	DELCOS XL Series
Category	Controller
Language	English