Regulatory Compliance Notices
B-7
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Carey Gregg Saved by: J Abercrombie Saved date: 05/11/00 4:05 PM
Part Number: 170706-002 File name: Appb
Laser Information
Laser Type: Semiconductor GaAlAs
Wave Length: 780
±
35 nm
Divergence Angle: 53.5
°
±
1.5
°
Output Power: Less than 0.2mW or 10,869 W·m
-2
sr
-1
Polarization: Circular
Numerical Aperture: 0.45
±
0.04
Only authorized technicians trained by Compaq should attempt to
repair this equipment. All troubleshooting and repair procedures
are detailed to allow only subassembly/module level repair.
Because of the complexity of the individual boards and sub-
assemblies, no one should attempt to make repairs at the
component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
European Union Notice
Products with the CE marking comply with Telecommunication
Terminal Equipment and Satellite Earth Station Equipment (TTE
& SES) Directive (98/13/EC), the EMC Directive (89/336/EEC)
and the Low Voltage Directive (73/23/EEC) issued by the
European Community.
Compliance with these directives implies conformity to the
following European Norms or Regulations (in brackets are the
equivalent international standards and regulations):
■
EN55022 (CISPR 22)—Electromagnetic Interference
■
EN50082-1 (IEC801-2, IEC801-3, IEC801-4)—
Electromagnetic Immunity
■
EN60950 (IEC950)—Product Safety
■
CTR21 (ETSI TBR21)—Attachment requirements for
connection to the analogue PSTNs of terminal equipment
The equipment has been approved in accordance with Council
Decision 98/482/EC for pan-European single terminal connection
to the Public Switched Telephone Network (PSTN). However, due
to differences between the individual PSTNs provided in different
countries, the approval does not, of itself, give an unconditional
assurance of successful operation on every PSTN network
termination point. In the event of problems, you should contact
your equipment supplier in the first instance.