Comtech EF Data HPOD - Telnet Operation Via Hyperterminal

HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier Revision 6
Ethernet-based Remote Product Management MN/HPOD.IOM
4–5


4.4.1 Telnet Operation via HyperTerminal
Thereisadis advantagewhenusingWindowsCommand‐lineasaTelnetclient.SinceCommand‐
linecannottranslatea‘\r’(i.e.,carriagereturnor“CR”)toa‘\r\n’(i.e.,CR+linefeed“LF”)forthe
messages coming from Telnet Server, any multi ‐line Target‐to‐Controller response (e.g., the
responsetotheFRW?qu
ery)willbedisplayedasoneline,withthelatterlinesoverwritingthe
previouslines.

In order to view the full response messages, Comtech EF Data recommends use of the
HyperTerminalterminalemulationprogram,configuredasaTelnetclient.

ConfigureHyperTerminalasfollows:
1. Ensurethattheconnectionis
madeusingTC
P/IP(Winsock)
insteadofCOM1orCOM2,as
shownatthenearright.

2. ASCIISetup(FileÆPropertiesÆ
SettingsÆASCIISetup):Check
the"Sendlineendswithline
feeds"optionintheASCIISending
section,andthe"Appendline
feedstoincominglineend
s"
optionintheASCIIReceiving
section,asshownatthefarright.
