Comtech EF Data HPOD - Config Pages

HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier Revision 6
Ethernet-based Remote Product Management MN/HPOD.IOM
4–17
• TrapIP1/TrapIP2–TheAdministratorcanassignuptotwoSNMPTrapIPaddressesinthe
form000.000.000.000.

• Trap Version – Use the drop‐down list to select the SNMP Trap as version SNMPv1 or
SNMPv2c.

Click[SubmitSNMP]tosavethesecha
nges,orclick[Reset]toreverttothepreviouslyassigned
SNMPsettings.
4.5.5.3 Config Pages
ClicktheConfigtab,andthenselecttheAmplifier,Utility,orRedundancyhyperlinktocontinue.
4.5.5.3.1 Config | Amplifier Page
Usethispag e to configure thecommunications, operations, andalarms/faultshandling  for the
amplifier.





















Figure 4-6. Config | Amplifier page
Atanytime,click[Refresh]toupdatethispageandseethemostrecentdata.
Amplifier
•
Attenuation(dB)–Enteranattenuationlevel,in0.25dBsteps,from00.00to20.00dB.