Comtech EF Data HPOD - Page 74

HPOD C, X-, or Ku-Band High-Power Outdoor Amplifier Revision 6
Ethernet-based Remote Product Management MN/HPOD.IOM
4–18
• Amplifier–Usethedrop‐downlisttosettheamplifierasOnorOff.
• Mute–Usethedrop‐downlisttosettheMutefunctionasEnabledorDisabled.

Click [ChangeConfiguration]tosave these settings,or click [Reset] to revert tothe previously
assignedAmplifiersettings.
Fault Recovery
Usethedrop‐downlisttosetFaultRecoveryasAutomaticorManual,andthenclick[Change].
BUC Mute
Usethedrop‐downlisttosetBUCMuteasMutedorNotMuted,andthenclick[Change].
Reference Adjust
Enteranumericvalue from0 to 255tosetthe referenceoscillator tuning voltage.Thedefault
voltagevalueis87.Click[Change]whendone.
Serial
• RemoteAddress–Enteraphysicalremoteaddressfrom0001to9999.

• BaudRate–Usethedrop‐downlisttosettheoperatingbaudrateas9600or19200bps.

Click[ChangeSerialConfiguration]tosavethesesettings.