Conair CSC - Puller Operation Problems

PULLER
OPERATION
PROBLEMS
UGE048/1103 CSC Combination Puller/Cutter
TROUBLESHOOTING 6-5
Symptom
◆ The puller
‘creaks’ while run-
ning.
◆ The puller does
not start.
Possible cause
The belt is too tight.
The bearings are failing.
The E-stop button is
pushed in.
Solution
Check the belt tension; loosen
if necessary. See Maintenance
section 5.
Replace the bearings.
Pull out the E-stop button.
(Make sure it clicks into posi-
tion.)