Conair CSC - INSTALLATION; Unpacking the Boxes; Preparing for Installation; Positioning the Combination Puller;Cutter

3-1
UGE048/1103 CSC Combination Puller/Cutter
●●
Unpacking the Boxes . . . . . . . .3-2
●●
Preparing for Installation . . . . . .3-3
●●
Positioning the
Combination Puller/Cutter . . .3-4
●●
Connecting the Main
Power Source . . . . . . . . . . . . .3-6
●●
Installing the Cutter
Blades . . . . . . . . . . . . . . . . . . .3-7
●●
Mounting the Cutter
Bushings . . . . . . . . . . . . . . . . .3-8
●●
Adjusting Belt Tension . . . . . .3-10
●●
Setting the Belt Gap . . . . . . . . .3-12
●●
Checking Repeatability . . . . . .3-14
●●
Repeatability Test Results . . . .3-15
●●
Preparing for Testing . . . . . . . .3-16
●●
Testing the Installation . . . . . .3-17
INSTALLATION