Move the combination puller/cutter into posi-
tion.
Place the puller/cutter in position downstream of
the last sizing or cooling tank.
Align the puller/cutter with the extrusion line.
CSC Combination Puller/Cutter UGE048/1103
3-4 INSTALLATION
1
POSITIONING THE
COMBINATION
PULLER/CUTTER
CAUTION: Lifting
To avoid personal injury or damage to the cut-
ter, lift the cutter using a forklift or hoist with
straps that have been positioned at the combo's
center of gravity.
2
Combination Puller/Cutter
Continued
To Next Page
Loading...