Conair CSC - How to Use the Lockout Device

WARNING: Electrical hazard
Before performing maintenance or repairs on
this product, disconnect and lock out electrical
power sources to prevent injury from unexpect-
ed energization or start-up. A lockable device
has been provided to isolate this product from
potentially hazardous electricity.
Lockout is the preferred method of isolating machines or
equipment from energy sources. Your Conair product is
equipped with the lockout device pictured below. To use the
lockout device:
Stop or turn off the equipment.
Isolate the equipment from elec-
trical power.
Turn the rotary discon-
nect switch to OFF or O position.
Secure the device with an assigned
lock or tag.
The equipment is now locked out.
CAUTION: Moving parts
Before removing lockout devices and returning
switches to the ON position, make sure that all
personnel are clear of the machine, tools have
been removed and all safety guards are rein-
stalled.
3
4
1
2
HOW TO USE
THE
LOCKOUT
DEVICE
1-6 INTRODUCTION
CSC Combination Puller/Cutter UGE048/1103