Conair CSC - Puller Operation Control

Apply power to the machine.
Place the disconnect in the “ON” position.
Check to insure to 10-turn speed potentiometer
is turned to zero speed. (Counter-clockwise fully).
Note: Whenever the puller is turned off,
the speed potentiometer should be rotated
to zero speed. In this way, when the unit is
started, it will be in a safe operational mode.
Open the gap between the puller belts to the desired
gap for the product to be pulled.
Depress the green “START” button to start the
drive.
Note: If the puller does not start, make sure
the “E-Stop” button is pulled out in the
extended position.
Using the 10-turn potentiometer, adjust the puller
speed.
Note: Turn in a clockwise direction to
increase speed and counter-clockwise to
decrease speed.
A digital line rate indicator (optional) can be used
to set the desired puller speed.
Note: This display should be programmed
in feet per minute, with one decimal point
(tenths of feet per minute), unless otherwise
specified.
1
3
4
2
5
6
PULLER
OPERATION
CONTROL
OPERATION 4-27
UGE048/1103 CSC Combination Puller/Cutter
NOTE: For optional Servo
Control see Appendix F.