Digital belt gap sensor and readout
This option allows the operator to set a zero point, then mea-
sure belt gap (in thousandths) relative to this point.
Pneumatic upper belt actuator
An air cylinder assembly that can raise and lower the upper
belt boom assembly is available on 426 models only. Control
can be either manual or electrical.
Remote belt speed control
This option allows puller speed control by an external source.
Electronic totalizing footage counter
This option allows the operator to view how much product has
passed through the puller based on input from an encoder. The
counter may be zeroed at any time and rescaled as needed.
Velocity servomotor with serial operator interface
The standard AC puller drive can be replaced by a velocity
controlled servomotor for applications requiring extreme accu-
racy.
Different reducer ratios
A particular reducer ratio is selected at the time of purchase to
optimize puller performance in a particular speed range.
Cutter Bushing Lubrication
This is a self-contained spray system, which includes a reser-
voir and air inlet for operation at 20-30 psig (air source not
included). A flexible nozzle directs lubricant onto the extru-
date as it enters the cutter bushings. This decreases bushing
drag and helps lubricate the blade. This option is particularly
recommended for processing sticky/soft (low durometer)
materials.
Cutter Blade Wipe
The blade wipe system keeps the cutting blade clean by
removing lubricant and particles from the blade. A reservoir
chamber with a flexible drip tube feeds lubricant to a felt pad
sandwiched between two pieces of stainless steel in the lubri-
cation tray. The pad wipes and lubricates the knife before each
cut.
PULLER
OPTIONAL
EQUIPMENT
CSC Combination Puller/Cutter UGE048/1103
DESCRIPTION 2-9
CUTTER
OPTIONAL
EQUIPMENT
Continued
To Next Page
Loading...