Configuration Guide. IPefono.
VoIP.sip.registerTime = 30
VoIP.sip.registerOnCall =
VoIP.sip.autoResolveName =
VoIP.autoconnect = TRUE
VoIP.listenModeIncommingCall =
VoIP.autoconnectTime = 0
VoIP.pushToTalk = FALSE
VoIP.useKeyboard =
VoIP.disableLightSignal =
VoIP.echoCanceller =
VoIP.echoCancellerLevel =
VoIP.echoCancellerFilter =
VoIP.echoAttenuation = 16
VoIP.noiseSuppression =
VoIP.noiseSupressionLevel =
VoIP.volume = medium
VoIP.volumeRing = low
VoIP.volumeTone =
VoIP.volumeMessage =
VoIP.volumeAux = mute
VoIP.volumeEmergency =
VoIP.gainMic = veryhigh
VoIP.sensitivityAux =
VoIP.portRTP = 5004
VoIP.codec = A-Law
VoIP.packetTime = 40 ms
VoIP.rtpInactivityTimeout =
VoIP.paging.ipMulticast =
VoIP.paging.portMulticast =
VoIP.paging.group = all
VoIP.maximumRingDuration =
VoIP.maximumOutgoingCallDuration =
VoIP.maximumCallDuration =
6 –
V2.8
Proxy registration time in seconds
Register only when an
pending
VoIP.sip.autoResolveName =
FALSE
Resolve the destination IP address using …
Automatically connecting
VoIP.listenModeIncommingCall =
FALSE
Connect incoming calls in listen mode …
Wait time in
seconds before connecting …
Push the call button to talk
Use keyboard to call if it is available
Disable the call status light indicator
Echo canceller
Higher output level to cut the microphone
…
Echo canceller filter factor
Echo canceller attenuation for the …
Suppress the back ground
VoIP.noiseSupressionLevel =
10
Lower noise level allowed
Conversation volume
Ring volume
Tone volume
Pre-recorded messages
Auxiliary input volume
Emergency message
Microphone input gain
Auxiliary input sensitivity
Real Time Protocol port
Voice codec for transmiss
Rtp packet length
RTP inactivity timeout in seconds
IP address for
VoIP.paging.portMulticast =
5004
RTP port for audio paging
Group paging address
VoIP.maximumRingDuration =
120
Expiration time of the incoming call in …
VoIP.maximumOutgoingCallDuration =
120
Expiration time of the
VoIP.maximumCallDuration =
60
Expiration time of the conversations in …
55
Proxy registration time in seconds
call is
Resolve the destination IP address using …
calls
Connect incoming calls in listen mode …
seconds before connecting …
Use keyboard to call if it is available
Disable the call status light indicator
Higher output level to cut the microphone
Echo canceller attenuation for the …
RTP inactivity timeout in seconds
Expiration time of the incoming call in …
Expiration time of the conversations in …