CONFIGURATION
17
If the parameter Switch to backup SIM card when data limit is exceeded (see next) or
Send SMS when datalimit is exceeded (see SMS configuration) are not selected the data
limit will not count.
1.10.5.
Switch between SIM cards configuration
At the bottom of configuration it is possible to set rules for switching between two
APN’s on the SIM card, in the event that one SIM card is inserted or between two SIM cards,
in the event that two SIM cards are inserted.
Item Description
Default SIM card This parameter sets default APN or SIM card, from which it will try
to establish the PPP connection. If this parameter is set to none, the
router launches in off-line mode and it is necessary to establish PPP
connection via SMS message.
Backup SIM card Defines backup APN or SIM card, that the router will switch
the defining one of the following rules.
Table 17: Default and backup SIM configuration
If parameter Backup SIM card is set to none, then parameters Switch to other SIM
card when connection fails, Switch to backup SIM card when roaming is detected and Switch
to backup SIM card when data limit is exceeded switch the router to off-line mode.
Item Description
Switch to other SIM
card when connection
fails
If PPP connection fails, then this parameter ensures switch
to secondary SIM card or secondary APN of the SIM card. Failure of
the PPP connection can occur in two ways. When I start the router,
when three fails to establish a PPP connection. Or if it is checked
Check the PPP connection, and is indicated by the loss of a PPP
connection.
Switch to backup SIM
card when roaming is
detected
In case that the roaming is detected this parameter enables
switching to secondary SIM card or secondary APN of the SIM card.
Switch to backup SIM
card when data limit
is exceeded
This parameter enables switching to secondary SIM card or
secondary APN of the SIM card, when the data limit of default APN
is exceeded.
Switch to backup SIM
card when binary
input is active
This parameter enables switching to secondary SIM card
or secondary APN of the SIM card, when binary input ‘bin0’ is active.
Switch to primary SIM
card after timeout
This parameter defines the method, how the router will try to switch
back to default SIM card or default APN.
Table 18: Switch between SIM card configurations
To Next Page
Loading...
