corob D300 - Adding Oil to Hydraulic Unit

24 3 - Maintenance instructions
COROB
TM
D300
3.7.3 Adding oil
If COROB
TM
D300 has for example fallen during transport, the oil in the cylinder and pump may
have leaked out. In this case you must add oil to the unit.
Installation oil: Mobil Oil Light ISO VG 32
Tools required:
• 5 mm Allen key
Procedure
1. Remove the can table from the COROB
TM
D300.
2. Remove the side plate.
3. Lower the table down.
4. Remove the filter from top of the pump, see figure 42 on page 21.
5. Pour oil through the hole.
6. Place the filter.
7. Vent the unit as instructed above.
8. Attach the can table assy back in COROB
TM
D300.
Figure 49: Tilt the can table assy like this so you
can vent the hydraulic lift unit.