2 - Machine installation 13
2.3 Mounting monitor cables
Procedure
1. Lift up the monitor arm and corner frame, figure 17.
2. Pass two protective hoses, length 450 mm, around the monitor cables as shown in figure 18.
3. Pass the cables inside the monitor arm.
4. Push the arm inside the beam.
5. Pass the cables over the beam behind the side plate.
6. Put the corner frame back in place.
Figure 17: The monitor arm and corner
frame are lifted up.
Figure 18: Two protective hoses, violet ones,
should be placed like this.
Figure 19: Both the arm and corner frame
are in place.
Figure 20: The cables run inside the left side
plate.
To Next Page
Loading...
