10 2 - Machine installation
COROB
TM
D300
2 MACHINE INSTALLATION
The COROB
TM
D300 is delivered packed in a wooden crate that, in addition to the dispensing
machine, contains an equipment package and all the ordered optional parts
.
2.1 Installation site requirements
To ensure ease of use, take into account the following details when installing the machine:
1. The machine should be operated at room temperature, in a room with no harmful humidity or
drafts and adequate air conditioning.
2. The machine must be placed away from direct sunlight.
3. The operating site must have adequate lighting.
4. Place the mains plug in such a place that it can be unplugged without moving the machine.
5. Check that the floor is not slippery or uneven.
6. Electrical interface:
100 - 240 V,
50/60 Hz / F 10 A
Earthed wall socket
7. Machine dimensions, see “Technical information” on page 8.
2.2 Installation
NOTE!: An instruction for removing the COROB
TM
D300 from the package is attached to the
machine!
Installation step by step:
1. Carefully remove the COROB
TM
D300 from the transport package:
- Remove the packing material around the machine
- Remove the equipment package and other possible accompanying equipment like
computer and monitor from the top of the foot.
- Remove the steel straps and planks that are used to attach the COROB
TM
D300 on the
pallet.
- Place the side of the transport package as a ramp: the other edge of the cover below the
foot of the COROB
TM
D300 and the other edge on the floor.
- Slide the COROB
TM
D300 along the ramp to the floor.
NOTE!: At least two persons must work together to remove the machine from the package.
NOTE!: The COROB
TM
D300 moves best backwards.
WARNING! Only a service representative authorised by the supplier may install the
machine.
CAUTION / IMPORTANT If the dispensing machine is brought in from a cold temper-
ature, wait one day before using the machine. The temperature difference may
condense moisture on the machine's components, which could damage the
machine's electronics when the power is switched on.
To Next Page
Loading...
