46 7 - Koecdriver
COROB
TM
D300
7.1.5 Stirring tests
Normally the COROB
TM
D300 is stirring colorants automatically using predefined stirring param-
eters, normal setup for the COROB
TM
D300 is like 1 minute of stirring in hour for each colorant.
Note that there are separate stirring motors for each canister, also the active stirring times can be
different for each canister.
We can also force the stirring to happen at once e.g. to test the stirring motors.
Select a proper time for stirring (e.g. 5 seconds). If you want to test all motors then select test
mode TopLeftDownRight, then test is done for all canisters in that order. If you want to test only
one canister/motor then select Manual mode and select also the canister to test. Test is activated
pressing A5-Stirring button, after test interval time the test stops automatically.
7.2 Configuration settings
Program also allows some basic configuration setups for the COROB
TM
D300 machine, see below
the available options.
To Next Page
Loading...
