3 - Maintenance instructions 31
4. Disconnect the stirring motor wire.
5. Place the side plate in position:
- Put the front into the beam’s groove
- Place the rear hooks into the holes in the upper frame.
6. Put the back panel back in place:
- Thread the hooks into the holes in the side plate
- Lower the back panel down
7. Put the cover in position.
8. Place the corner frame in place.
9. Switch on the COROB
TM
D300.
10. Dispense 150 millilitre of colorant from the new canister to fill in the hoses.
Figure 67: Thread the canister from above in
position.
Figure 68: Place the tool between the tap and
it’s sleeve and push the sleeve outwards.
Figure 69: Place the side plate’s front into the
beam’s groove.
Figure 70: Thread hooks in back of the
side plate into the holes of the upper
frame.
To Next Page
Loading...
