Crystal Instruments Coco-80 - Setting the Acquisition Mode; Setting the Overlap Ratio

CoCo-80 User Manual
101
CoCo-80 Operation for Spectral Analysis
This section describes the operations of CoCo that are specifically related to the
FFT spectral analysis. For general operations of CoCo, refer to the previous
chapters of this manual.
Select a CSA Project
To run a spectral analysis CSA, press the Analysis button and select either the
Linear and Power Spectra or the Frequency Response Application group, then
select one of the CSA spectral analysis projects.
Figure 110. CoCo Select Analysis Function selection display.
Set Analysis Parameters for Spectral Analysis
To set the parameters for spectral analysis, press the Param. Button in the signal
display window, select Analysis Parameters, then set the parameters.