CoCo-80 User Manual
64
Figure 87: Recalling data files
A signal can be recalled into an existing trace or a new trace. Recalling into an
existing trace will plot this signal over the other signals in that trace.
The signal can also be played back through the output channel of the CoCo. To do
this, press F5 (Playback), and then press F1 (Start Output). All annotations
attached to this signal will also be displayed in this view.
Figure 88: List of voice annotations associated with the selected file
Rec./Stop Button
Pressing Rec./Stop will start or end a time stream recording. The CoCo will
function similar to a tape recorder, recording all data from the selected inputs
continuously until Rec./Stop is pressed again or there is no remaining memory.
Recording files are named RECxxxx.
To Next Page
Loading...
