CoCo-80 User Manual
116
Signals Continuously. This option can be used to view all data blocks on a
waterfall plot.
Save Points
Save Points function saves a data point per signal at one time. This function is
particularly useful in the very long period monitoring applications. For example
people can save and monitor the vibration or acoustic level over a few months by
looking at the data points saved every hour.
All data points in one test will be saved into one data file. The user can easily
open, view and analyze the data files using EDM PC software.
To set up the Save Points, first go to Param.->Signal Save Predefined List screen,
then press F4 the Save Point Setup button, a tab display will be shown. The user
can select Current Value, Max, Min, Peak, Average, or RMS for time signals or
Peak, RMS, or Frequency of Peak for spectral data. In the Sound Level Meter
function, Leq or Lmax can also be selected.
Using Schedule to Save Data
An automated schedule can be developed for recording the time streams, saving
the block signals or data points.
1. Restart
2. Hold
3. Run Duration regardless Trigger
4. Run Duration after Trigger
5. Waiting for one time
6. LOOP
7. END LOOP
8. Limit check ON
9. Limit check OFF
10. Start Recording
11. Stop Recording
12. Save Signals
13. Turn signal source ON
14. Turn signal source OFF
15. Activate Timer to Save Signals
16. Deactivate Timer to Stop Saving Signals
17. Set all input mode
To make a schedule, first go to the Schedule Setup screen:
To Next Page
Loading...
