Crystal Instruments Coco-80 - CoCo Operation for Transient Capture; Selecting a CSA Project for Transient Capture; Transient Capture Analysis Parameters

CoCo-80 User Manual
103
Figure 112. CoCo. Spectrum Type selection display.
Set the Output Channel Parameters
To enable the output channel as a function generator select Output Channel from
the Param. Button. Next select the waveform. To set the amplitude and
frequency and other parameters move the cursor to the parameter and press the
Enter Button to edit the parameter.
To select an arbitrary waveform first select Arb Wave as the output type, then
press the Arbitrary Wave Button to choose from all the wave files that are loaded
on the CoCo.
Figure 113. Output parameters.